I needed to tap an expensive (about $1000) item. The material I wanted to tap is a hard steel, but I do not know the specific alloy or hardening process used. Not wanting to have the tap snap off inside the costly part, I bought 6 different taps, all in M6x1, to see if any would do the job. Here’s what I found:These taps were the 2rd best out of 6. The thread length is 24mm, it has 3 flutes, the taper is long so it’s easy to start, but these taps will not cut threads to the bottom of a hole. They are made in either India or Japan. These taps needed 2.5 Nm of torque to cut threads in the steel I was tapping. (The best tap needed 1.2 Nm, the worst needed 4.5 Nm.) Two taps were sent for the price. The price per tap was the second lowest of the 6 different taps I bought.